Nikon D3200 LCD Screen Replacement

Step 1 Battery

• Locate the battery compartment on the bottom of the camera directly below the mode dial.

Step 2

• Find the marked arrow on the battery compartment door and firmly push following the arrow's direction to release the latch.

I don't think its wise to install a battery when your going to be removing the control board as this could cause a short circuit and the board and or the battery could burn up, you should remove the battery prior to working on the internal parts of the camra

I quite agree, I once had the misfortune to get a severe electric shock from the gubbins of a digital camera.

It is best too remove battery and wait for capacitors to discharge.

It would be advisable for this guide to be redone

Step 3

• Release the latch and allow it to completely open.

• Insert the battery by following the diagram on the inside of the compartment door.

• Close the compartment door and firmly press on the latch until you hear a clicking sound.

Step 4 LCD Screen

• Turn the camera so the bottom faces you.

• Locate and remove the 6 screws using a Phillips #00 screwdriver.

Step 5

• Locate the rubber grip directly below the shutter-release button.

• Lift the rubber grip using a plastic opening tool to locate and remove the two screws underneath using a Phillips screwdriver #00.

I'd greatly appreciate if there was pictures to see how to lift it

Step 6

• Locate and remove the 4 screws above the LCD screen, around the eyepiece. Use a razor to carefully peel the sticker off the +/- wheel to reveal the screw beneath.

And I'd greatly appreciate if there was pictures to see how to lift the sticker

Step 7

• Locate the connector cover left of the LCD screen.

• Unlatch the connector cover to reveal two screws.

• Remove screws.

Antes del siguiente paso, hay que levantar la goma en forma de triángulo en la parte superior dereche de la pantalla para retirar el tornillo que está debajo.

Hello, you've forgot a very tiny screw, under the fake leather band, just under the mode dial, at the back side of the body. Otherwise, your explainations for the repair of the LCD screen is really good…

Step 8

• Remove the rubber connector cover.

• Gently pull the back portion of the camera, one hand gripping the body and the other gripping the LCD screen.

Step 9

• Lay the back cover, LCD side down.

• Locate and remove the 9 screws around the silver protector plate.

Step 10

• Using a pair of tweezers, gently lift and remove the silver protector cover.

Step 11

• Lift the yellow connector.

• Flip the white clasp using a plastic opening tool, and pull out the tab.

Be very very careful, the white, even the plastic opening tool is very very fragile.

Step 12

• Lift the yellow sheet to reveal the LCD screen.

Step 13

• Remove LCD screen.