Water Dancing Speakers Refill

Step 1 Water plug & water

• You will need to have a clean work space, water dancing speakers, super glue, mineral water, and Phillips screw driver ready.

• Unplug the USB cable powering your speakers before you continue.

i see a tiny hole on top of the glass speakers. but i see no obvious way to open it. it seems to me though that this would be where i should add the mineral oil. Anyone else have the same speakers i have? any ideas on how to open it… without damaging the glass?

Step 2

• Using the phillips screw driver remove the 4 screws seen on the back of speakers.

Step 3

• Once the four screws are taken out you will need to slide the bottom piece from the water canister.

• When the two are separated set the water canister bottom facing up.

I have got the same speakers, and You should refill it with water but one inch of the top so almost full. Just correcting your stupid mistake You smarty pants. Thank You!!!

Step 4

• On the bottom of the water canister you will see a hole where the water was inserted. There will be a black plug covering the hole.

• Using your screw driver you can pry the plug out.

• Once the plug is taken out you can refill the speakers. Only refill the speakers with one inch of water.

I tried prying it but it didn't work and I ended up breakin the little space it was in.

Mine didn't have a plug, and I had to use a very small bit to drill the hole open. added water and glued. works okay, except it makes a random 'grinding' noise and the liquid in the refilled one doesn't cascade like the original - almost as if the original liquid was not water - at least not plain water. Any thoughts?

it's mineral oil

Just bought these speakers; there's only about an 1/8" of water in them. Took it apart with your instructions and found water plug… It's tiny! How did you add water? A syringe? Also in the picture the water tank appears full, you say add one inch. We don't understand (duh), could you explain please?

Only the inch of water in the bottom of the water tank is shot up into the air in the water tank.

Step 5

• After the water is filled to approximately one inch. Super glue the hole shut and let dry.

Step 6

• When the glue is dry slide speaker back on to water canister.

• Once they are put together place back panel on and insert the four screws.

• repeat steps 2 through 6 on second speaker.

Can you showe me how to fixs my water speakers